How to Install the Wallbox Pulsar Max

What You'll Need

• Wallbox Pulsar Max
• 50A or 60A circuit breaker (for 48A model)
• 6 AWG copper wire
• Appropriate conduit
• Electrical tools
• Wallbox app
• 2.4GHz or 5GHz WiFi network

Step-by-Step Installation

1. Disconnect power: Turn off the main breaker at your electrical panel.
2. Choose location: Select a spot that allows the 25-foot cable to reach your vehicle. Pulsar Max is outdoor rated.
3. Install circuit breaker: Add the appropriate breaker to your panel based on your Pulsar Max model (40A or 48A).
4. Mount the unit: Use the included bracket to mount at a height between 2-4 feet from ground level.
5. Run wiring: Route wire from panel to charger through weatherproof conduit.
6. Connect wires: Open the Pulsar Max terminal cover. Connect L1, L2, and ground to marked terminals.
7. Configure Power Boost (optional): If using dynamic load management, install the included CT clamp on your main feed.
8. Restore power: Turn on the breaker. The Pulsar Max halo will illuminate.
9. Set up Wallbox app: Download and create a Wallbox account.
10. Add charger: Tap "Add Charger" and scan the QR code on your Pulsar Max.
11. Connect to WiFi: Follow app prompts to join your home network.

Key Features

• Up to 48A / 11.5kW charging
• Power Boost dynamic load management
• Dual WiFi (2.4GHz and 5GHz)
• Bluetooth for offline configuration
• Alexa, Google Home, and HomeKit compatible
• Compact, award-winning design

Troubleshooting

• Halo flashing red: Error detected. Check the app for specific error code and resolution.
• Power Boost reducing output too much: Verify CT clamp is installed correctly on the main line, not a sub-panel feed.
• App not connecting: Ensure Bluetooth is enabled on your phone for initial setup.
• Charger going offline: Check WiFi signal strength at the charger location. Consider a WiFi extender if weak.