How to Set Up Your Eaton Z-Wave Plus Smart Receptacle

What You'll Need

• Eaton Z-Wave Plus Smart Receptacle
• Z-Wave hub (SmartThings, Hubitat, Vera, etc.)
• Neutral wire at outlet box
• Screwdriver and voltage tester

Step-by-Step Setup

1. Turn off power at the breaker
2. Verify power is off with voltage tester
3. Wire the receptacle:
   • Hot wire to brass terminal
   • Neutral wire to silver terminal
   • Ground wire to green terminal
4. Install in electrical box
5. Turn on power
6. Add to Z-Wave network:
   • Put your hub in inclusion mode
   • Press the receptacle button once
   • LED will flash during inclusion
   • Solid LED confirms successful pairing

Key Features

• Z-Wave Plus certified for improved range
• Works as Z-Wave repeater
• Split receptacle design
• S2 security framework support
• LED status indicator
• Works with any Z-Wave certified hub

Troubleshooting

• Inclusion fails: Exclude first by putting hub in exclusion mode and pressing receptacle button
• LED flashing rapidly: Receptacle in pairing mode - complete inclusion or reset
• No response: Check Z-Wave network health and try re-including
• Factory reset: Press and hold button for 10+ seconds until LED flashes