How to Set Up Your Inovelli Red Series Z-Wave Smart Outlet

What You'll Need

• Inovelli Red Series Z-Wave Smart Outlet
• Z-Wave hub (SmartThings, Hubitat, Home Assistant)
• Neutral wire at outlet box
• Screwdriver and voltage tester

Step-by-Step Setup

1. Turn off power at the circuit breaker
2. Confirm power is off with a voltage tester
3. Connect wiring:
   • Line (hot) to brass terminal
   • Neutral to silver terminal
   • Ground to green terminal
4. Mount outlet and faceplate
5. Restore power
6. Pair with hub:
   • Put hub in inclusion mode
   • Triple-press the outlet button
   • RGB LED strip will flash cyan during pairing
   • LED turns green when paired successfully

Key Features

• Z-Wave 700 series chip
• RGB LED notification bar (configurable colors)
• Energy monitoring built-in
• Scene control support (multi-tap)
• SmartStart ready for instant pairing
• S2 authenticated security
• OTA firmware updates

Troubleshooting

• Won't pair: Exclude first (triple-press while hub is in exclusion mode), then include
• LED not working: Configure LED settings in hub's device parameters
• Energy monitoring not showing: Ensure hub supports meter reporting
• Factory reset: Hold button 20+ seconds until LED flashes red