How to Set Up Your Zooz ZEN20 Z-Wave Plus Outlet

What You'll Need

• Zooz ZEN20 Z-Wave Plus Power Strip (5 outlets)
• Z-Wave smart home hub
• Standard 120V outlet to plug into

Step-by-Step Setup

1. Plug in the ZEN20 to any standard 120V outlet
2. Wait for initialization - LEDs will cycle through during startup
3. Add to Z-Wave network:
   • Put your hub in inclusion mode
   • Press the Z-Wave button on the side of the power strip
   • LED will flash rapidly during pairing
   • The hub will discover 5 separate outlet endpoints
4. Configure in hub:
   • Name each of the 5 outlets individually
   • Set up automations as desired

Key Features

• 5 individually controllable Z-Wave outlets
• Z-Wave Plus 500 series for extended range
• Works as Z-Wave repeater
• Manual on/off buttons for each outlet
• LED indicators per outlet
• 2 always-on USB ports (2.1A total)
• Surge protection built-in

Troubleshooting

• Only one outlet showing: Ensure hub properly discovers all endpoints; check hub documentation for multi-endpoint devices
• Pairing fails: Exclude first, then factory reset (hold Z-Wave button 10 seconds)
• LEDs stay off: Check that LED indicator setting isn't disabled in parameters
• USB ports not charging: USB ports are always-on; check cable and device