How to Set Up Your Zooz ZEN25 Z-Wave Double Plug Power Strip

What You'll Need

• Zooz ZEN25 Z-Wave Plus S2 Double Plug
• Z-Wave hub (SmartThings, Hubitat, Home Assistant, etc.)
• Z-Wave network set up and working

Step-by-Step Setup

1. Plug in the ZEN25: Connect directly to a wall outlet. Both outlet LEDs will flash
2. Enter inclusion mode on hub: Start Z-Wave device inclusion/pairing
3. Press the Z-Wave button: Click the button on the ZEN25 once
4. S2 security: If prompted, enter DSK code from device or scan QR code
5. Wait for discovery: Hub will add the double plug with both outlets
6. Name each outlet: Left and right outlets appear as separate switches
7. Test operation: Toggle each outlet independently
8. Configure parameters: Adjust LED, auto-off, power reporting as needed

Key Features

• 2 outlets: Independent control of left and right outlets
• S2 security: Latest Z-Wave security protocol
• Energy monitoring: Detailed power, voltage, current reporting per outlet
• USB port: Always-on USB charging
• Compact design: Doesn't block adjacent outlet
• 700 series compatible: Works with latest Z-Wave controllers

Troubleshooting

• S2 pairing fails: Ensure your hub supports S2. Try including without security as fallback
• One outlet missing: Re-interview the device. May need to remove and re-add
• Power readings off: Calibrate by checking Parameter 152 and 153 in Z-Wave settings
• Factory reset: Press and hold Z-Wave button for 10+ seconds until LED flashes
• Exclusion: Put hub in exclusion mode, then press Z-Wave button once