How to Set Up Your Fibaro Flood Sensor

Intermediate 10-15 minutes

What You'll Need

  • Fibaro Flood Sensor
  • Z-Wave hub (SmartThings, Hubitat, Home Assistant, Fibaro HC3)
  • Z-Wave network configured
  • CR123A battery (included)

Step-by-Step Setup

  1. Open the sensor: Twist to open the round casing
  2. Insert battery: Install CR123A battery
  3. Put hub in inclusion mode: Start Z-Wave pairing
  4. Include sensor: Press the TMP button 3 times quickly
  5. Wait for inclusion: Hub will add the sensor
  6. Configure parameters: Adjust alarm settings if needed
  7. Place sensor: Set on floor with legs touching surface
  8. Test: Tilt to test tilt sensor; pour water near legs to test flood

Key Features

  • Beautiful design: Distinctive eye-like appearance
  • Multi-sensor: Water, temperature, and tilt detection
  • Tilt alarm: Alerts if sensor is moved/tilted
  • Temperature sensor: Monitors ambient and water temperature
  • Visual alarm: LED changes color when triggered
  • Z-Wave Plus: Extended range and reliability

Troubleshooting

  • Won't include: Exclude first if previously paired
  • Tilt false alarms: Ensure sensor is on stable surface
  • Water not detected: Ensure all 3 gold legs are touching floor
  • LED meanings: Check manual for LED color codes
  • Factory reset: Hold TMP button for 15+ seconds