Installing Your Ring Battery Doorbell Plus

Beginner 20-40 minutes

What You Will Need

  • Ring Battery Doorbell Plus
  • Ring app (iOS or Android) with an active account
  • A 2.4 GHz WiFi network
  • Charged battery pack (charge using the included USB-C cable before installation)
  • Phillips screwdriver or drill
  • Mounting screws and anchors (included)
  • Level (optional)

Step 1: Charge the Battery

Before installation, fully charge the included rechargeable battery pack. Connect the USB-C cable to the battery and plug it into a USB power adapter. The LED indicator on the battery will turn solid green when fully charged. A full charge takes approximately five to six hours.

Step 2: Set Up in the Ring App

  1. Open the Ring app and tap Set Up a Device.
  2. Select Doorbells, then choose Battery Doorbell Plus.
  3. Scan the QR code on the back of the doorbell or on the Quick Start Guide.
  4. Insert the charged battery into the doorbell. The button on the front will glow as the device powers on.
  5. Follow the on-screen prompts to connect the doorbell to your 2.4 GHz WiFi network.
  6. Name your doorbell and assign it to a location.

It is recommended to complete the app setup before mounting the doorbell so you can confirm WiFi connectivity at the intended installation location.

Step 3: Mount the Doorbell

  1. If you have an existing wired doorbell, remove it and disconnect the wires. The Battery Doorbell Plus can optionally use existing doorbell wiring (16-24 VAC) to trickle-charge the battery, but it is not required.
  2. Hold the included mounting bracket against the wall next to your door at approximately four feet above the ground. Use a level to ensure it is straight.
  3. Mark the screw holes, then drill pilot holes. Insert wall anchors if mounting on brick or masonry.
  4. If using existing doorbell wires, thread them through the bracket and connect them to the terminals on the back of the doorbell.
  5. Secure the mounting bracket with the included screws.
  6. Snap the doorbell onto the bracket and tighten the security screw at the bottom using the included tool.

Step 4: Configure Motion Settings

The Battery Doorbell Plus features a head-to-toe HD+ video with a tall 150 x 150 degree field of view. Configure your motion settings to get the most out of it:

  • Motion Zones — Define specific areas within the camera's field of view to monitor. Exclude areas like busy sidewalks to reduce unnecessary alerts.
  • Motion Sensitivity — Adjust the slider to balance between catching important events and minimizing false notifications.
  • Smart Alerts — With a Ring Protect plan, enable package and person detection for more relevant notifications.

Step 5: Test Your Doorbell

  1. Press the doorbell button and verify you receive a notification on your phone.
  2. Check the live view to confirm the camera angle captures your porch and walkway.
  3. Walk through the motion detection zone and verify you receive a motion alert.
  4. Test the two-way audio by speaking through the app while standing at the door.

Tips for Best Performance

  • Battery life typically lasts six to twelve months depending on activity level. High-traffic areas drain the battery faster.
  • For continuous charging, connect to existing doorbell wiring or add a Ring Solar Charger.
  • Use the included wedge kit to angle the doorbell up to 15 degrees if needed to better capture your walkway.
  • A Ring Protect subscription is required to store and review recorded video clips.

Related Guides

Was this guide helpful?