How to Set Up Your Fibaro Motion Sensor

Intermediate 10-15 minutes

What You'll Need

  • Fibaro Motion Sensor
  • Z-Wave hub (SmartThings, Hubitat, Home Assistant, Fibaro HC3)
  • Z-Wave network configured
  • CR123A battery (included)

Step-by-Step Setup

  1. Open the sensor: Twist the eye-shaped casing to open
  2. Insert battery: Install CR123A battery
  3. Put hub in inclusion mode: Start Z-Wave pairing
  4. Include sensor: Press the B-button 3 times quickly
  5. Wait for inclusion: Hub will add the multi-sensor
  6. Configure parameters: Adjust sensitivity, LED brightness, etc.
  7. Mount: Use magnetic holder or included mount
  8. Test: Walk in front to verify motion detection

Key Features

  • Multi-sensor: Motion, temperature, light, and vibration
  • Beautiful design: Distinctive eye-shaped appearance
  • LED indicator: Color-changing LED shows temperature
  • Adjustable sensitivity: Fine-tune via Z-Wave parameters
  • Tamper detection: Alerts if sensor is moved
  • Z-Wave Plus: Extended range

Troubleshooting

  • Won't include: Exclude first if previously paired
  • LED too bright: Adjust LED brightness via parameter 80
  • False motion: Adjust sensitivity via parameters
  • Temperature offset: Calibrate via parameter 66
  • Factory reset: Hold B-button for 15+ seconds