Installing Your Zooz ZEN76 Z-Wave Plus 700 S2 Switch

What You'll Need

• Zooz ZEN76 Z-Wave Plus Switch
• Phillips head screwdriver
• Wire strippers
• Voltage tester
• Z-Wave hub
• Neutral wire required

Step-by-Step Setup

1. Turn off power: Switch off circuit breaker.
2. Remove existing switch: Unscrew and disconnect wires.
3. Identify wires: Line, Load, Neutral, and Ground. Line/Load cannot be swapped.
4. Wire the switch: Connect wires to corresponding terminals.
5. Mount switch: Secure in wall box.
6. Attach wall plate: Install Decora-style plate.
7. Restore power: Turn breaker back on.
8. Include in Z-Wave: Put hub in inclusion mode, then tap upper paddle 3 times.
9. Configure: Set preferences in hub app.

Key Features

• On/Off relay - no dimming
• Z-Wave Plus 700 series with S2
• 15A capacity for larger loads
• Simple 3-way/4-way with regular switches
• Scene control with multi-tap
• Programmable LED indicator
• Slim 1.16" depth
• SmartStart QR code inclusion

Troubleshooting

• Switch not responding: Check wiring connections. Verify breaker is on.
• Inclusion fails: Move hub closer or add Z-Wave repeaters.
• 3-way issues: Install Zooz switch in box with direct line connection.
• LED too bright: Adjust or disable LED in hub settings.