Inovelli Z-Wave Switch Not Pairing or Responding

Inovelli Z-Wave switches offer advanced features like LED notifications. This guide covers pairing issues.

Switch Not Pairing

1. Put Z-Wave hub in inclusion mode
2. Press config button 3 times
3. LED bar indicates pairing status
4. Keep hub nearby during pairing
5. Exclude first if previously paired

Installation Requirements

1. Turn off breaker before installation
2. Neutral wire required for most models
3. Red Series works without neutral (limited)
4. Check load compatibility before install
5. Ground wire required

LED Notifications

1. LED bar programmable for notifications
2. Set colors, effects, brightness via parameters
3. Use for doorbell, alarm, laundry alerts
4. Home Assistant exposes LED controls
5. Configure via Z-Wave JS UI

Fan + Light Switch Features

1. Single switch controls both fan and light
2. Uses canopy module for fan speed
3. Separate controls for each load
4. 4 fan speeds available
5. Light dimming independent

Scene Control

1. Multi-tap triggers scenes
2. Double, triple, hold, release actions
3. Central scene commands to hub
4. Configure in SmartThings or HA
5. Use for room-wide control

Home Assistant Setup

1. Z-Wave JS integration recommended
2. Parameters adjustable in Z-Wave JS UI
3. LED notifications via number/select entities
4. Scene triggers as device automation
5. Community Blueprints available