How to Set Up Your Aeotec WallMote Quad

Intermediate 5-10 minutes

What You'll Need

  • Aeotec WallMote Quad
  • Z-Wave hub (SmartThings, Hubitat, Home Assistant, etc.)
  • Z-Wave network configured
  • USB-C cable for charging (included)

Step-by-Step Setup

  1. Charge the WallMote: Connect USB-C and charge until LED indicates full
  2. Put hub in inclusion mode: Start Z-Wave pairing
  3. Include WallMote: Press and hold any button for 3 seconds until LED pulses
  4. Complete inclusion: Wait for hub to add device
  5. Configure buttons: Set up actions for each of the 4 touch buttons
  6. Configure swipes: Each button supports swipe up/down for dimming
  7. Set associations: Associate with Z-Wave devices for direct control
  8. Mount: Use magnetic wall mount (included)

Key Features

  • 4 touch buttons: Capacitive touch with LED feedback
  • Swipe gestures: Swipe up/down on each button for dimming
  • Rechargeable: Built-in battery, charges via USB-C
  • Central Scene: Full Z-Wave scene support
  • Association groups: Direct control of Z-Wave devices
  • Modern design: Sleek glass-like appearance

Troubleshooting

  • Touch not responding: Ensure charged. Clean surface if dirty
  • Swipes not detected: Swipe slowly and deliberately on the button
  • Won't include: Exclude first, then re-include. Hold button longer
  • Button LEDs off: Customize LED behavior via Z-Wave parameters
  • Factory reset: Press and hold button 1 for 20+ seconds