How to Set Up Your Inovelli Blue 2-in-1 Switch + Remote

Advanced 5-10 minutes

What You'll Need

Inovelli Blue Series 2-in-1 Dimmer Switch
Zigbee hub (Home Assistant/ZHA, Hubitat, SmartThings)
Neutral wire (recommended but not always required)
Basic electrical tools

Step-by-Step Setup

Turn off power: Switch off breaker to the circuit
Wire the switch: Connect Line, Load, Neutral (if available), and Ground
Power on: Turn breaker back on
Put hub in pairing mode: Enable Zigbee device discovery
Include the switch: Press config button 3 times
Configure in hub: Set dimming parameters, LED color, etc.
Set up scenes: Configure multi-tap scenes for remote control
Create automations: Link taps to smart home actions

Key Features

2-in-1 functionality: Controls local load AND triggers scenes
Multi-tap scenes: 2x, 3x, 4x, 5x tap, and hold actions
RGB LED bar: Customizable notification LED
Smart bulb mode: Disable relay for always-on smart bulbs
Zigbee binding: Direct bind to other Zigbee devices
Power monitoring: Energy usage reporting

Troubleshooting

Won't pair: Factory reset first - config button 3x, then hold for 20 seconds
LED bar not working: Configure LED settings in hub
Multi-tap not detected: Ensure hub has proper Inovelli driver/integration
Flickering lights: Adjust minimum dim level, or add bypass for low-wattage loads
Factory reset: Press config button 3x, then hold until LED turns red