Aeotec WallMote or NanoMote Not Responding

Aeotec WallMote and NanoMote are Z-Wave scene controllers. This guide covers pairing and button response issues.

Remote Not Pairing

1. Put Z-Wave hub in inclusion mode
2. WallMote: Press and hold any button 2 seconds
3. NanoMote: Hold middle buttons together
4. Keep remote within 3 feet of hub
5. Exclude first if previously paired elsewhere

Button Presses Not Detected

1. Configure central scene in hub
2. SmartThings: Use button controller automation
3. Home Assistant: Use device triggers, not entities
4. Scene IDs: 1-4 for buttons, actions for press type
5. Test with developer tools event listener

Swipe Gestures (WallMote)

1. Swipe gestures send different scene IDs
2. Configure swipe sensitivity in parameters
3. Up/down swipes may trigger dimming scenes
4. Gestures can be disabled if not needed
5. Clean surface for better swipe detection

Battery Draining Fast

1. Check wakeup interval setting
2. Increase interval to save battery (3600+ seconds)
3. Replace with quality CR2450 batteries
4. Normal battery life is 1-2 years
5. Frequent use decreases battery life

Home Assistant Setup

1. Device triggers appear in automation triggers
2. Select "Device" trigger type
3. Choose button number and action type
4. Actions: pressed, released, held, released after hold
5. Use Blueprint automations for easier setup

Wall Mounting

1. Mount with included adhesive or screws
2. Metal backing plates may reduce range
3. Keep within Z-Wave network range
4. Avoid mounting near WiFi routers