What You'll Need

Step-by-Step Installation

Measure your window: FYRTUR blinds come in fixed sizes. Verify your blind fits within the window frame or measure for outside mount.
Charge the blind: Connect the included USB cable to the blind's charging port. Charge fully before installation (approximately 8 hours).
Install mounting brackets: Position the brackets at each end of the window frame. Use the level to ensure they're aligned. Drill pilot holes and secure with screws.
Set the blind length: Before mounting, adjust the bottom position by manually rolling the blind to your desired stopping point.
Mount the blind: Insert one end of the roller into a bracket, then snap the other end into place. The blind should click securely.
Test manual operation: Pull down gently to extend. Give a slight tug to activate auto-retraction.
Set up the hub: If not already done, set up your DIRIGERA hub using the IKEA Home Smart app.
Pair the blind: In the app, tap "Add Device" and select "Blinds." Press the pairing button on the blind (small button near the charging port) and hold for 5 seconds.
Calibrate positions: Follow the app prompts to set the fully open and fully closed positions.
Create schedules: Set up sunrise/sunset automation or custom schedules in the app.

Blind not responding: Check battery level in app. Recharge if below 20%.
Pairing fails: Move the blind closer to the hub temporarily. Reset blind by holding pairing button for 10 seconds.
Blind stops mid-way: Recalibrate the open/close positions in the app.
Signal repeater not helping: Position the repeater between the hub and the blind, plugged into an outlet.

Was this guide helpful?